BMPYJ - BLACK ASPHALT VARNISH BALCK 17038
- MSDS: BMPYJ
- Manufacturer: FARWEST PAINT MANUFACTURING CO
- Product Name: BLACK ASPHALT VARNISH BALCK 17038
- National Stock Number: 8010-00-160-5856
Product Identification
Product ID:BLACK ASPHALT VARNISH BALCK 17038
MSDS Date:08/23/1990
FSC:8010
NIIN:00-160-5856
MSDS Number: BMPYJ
Responsible Party
TUKWILA, WA 98168
US
Emergency Phone: 206-941-1619
Info Phone: 206-244-8844
Cage: 2F266
Contractor
Telephone: 206-244-8844
Cage: 2F266
Ingredients
ALIPHATIC HYDROCARBON (VAPOR PRESSURE 2.0 MM HG @
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 48 - 53%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM; 9293
AROMATIC HYDROCARBON (SARA 313) (VAPOR PRESSURE 22 MM HG @
CAS: 1330-20-7
RTECS: ZE2100000
Fraction By Weight: 1 - 5%
OSHA PEL NOT ESTBLISHED
ACGIH TLV: 100 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
ETHYLENE GLYCOL MONO N-PROPYL ETHER (VAPOR PRESSURE 1.3 MM
CAS: 2807-30-9
RTECS: KM2800000
Fraction By Weight: 7%
ACGIH TLV: 25 PPM
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:EYES: CAN CAUSE SEVERE IRRITATION,
REDNESS, TEARING, BLURRED VISION. SKIN: PROLONG/REPEATED-CAN CAUSE
MODERATE IRRITATION, DEFATTING, DERMATITIS. INHAL: NASAL,
RESPIRTORY IRRITATION, DIZZINESS, WEAKNE SS, FATIGUE, NAUSEA,
HEADACHE, POSSIBLEUNCONSCIOUSNESS, ASPHYXIATION. INGEST:
GASTROINTESTINAL IRRITATION, NAUSEA,
Effects of Overexposure:VOMITING, & DIARRHEA. ASPIRATION OF MATERIAL
INTO LUNGS CAN CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL.
First Aid
First Aid:SKIN: WASH W/SOAP & WATER. REMOVE CONTAM CLOTH. EYES: FLUSH
W/LARGE AMOUNTS OF WATER, LIFTING EYLIDS OCCASIONALLY. GET MED AID.
INGEST: DON'T INDUCE VOMITING. KEEP WARM, QUIET. GET MED AID.
ASPIRATION OF MAT'L INTO LUNGS DUE TO VOMITING CAN CAUSE CHEM
PNEUMONITIS (CAN BE FATAL). INHAL: REMOVE TO FRESH AIR. IF
BREATHING IS21FEB92ULT, ADMIN OXYGEN. NO BREATH START ARTIF RESP.
KEEP QUIET. GET MED AID
Fire Fighting
Flash Point Method:TCC
Flash Point:100F,38C
Lower Limits:1.0%
Extinguishing Media:FOAM, CO2, DRY CHEMICAL.
Fire Fighting Procedures:NEVER USE NEAR OR AROUND WELDERS OR CUTTING
TORCHES. DRUM (EVEN EMPTY) BECAUSE PRODUCT (EVEN JUST RESIDUE) CAN
IGNITE EXPLOSIVELY.
Unusual Fire/Explosion Hazard:SELF-CONTAINED BREATHING APPARATUS WITH A
FULL FACEPIECE OPERATED IN PRESSURE-DEMAND OR OTHER POSITIVE
PRESSURE MODE.
Accidental Release
Spill Release Procedures:SMALL: USE ABSORBENT. TRANSFER TO HOOD. LRG:
ELIMINATE IGNITION SOURCES. EVAC UNPROTECTED. STOP SPILL. DIKE.
PUMP LIQ TO SALVAGE TANK. USE ABSORBENT ON REMAIN LIQ. PREVENT
RUNOFF TO SEWERS/ STREAMS/ET C. IF RUNOFF OCCURS NOTIFY AUTHORITIES
AS REQUIRED
Handling
Handling and Storage Precautions:CONTAINERS OF MATERIAL MAY BE
HAZARDOUS WHEN EMPTIED, SINCE EMPTIED CONTAINERS RETAIN PRODUCT
RESIDUES (VAPOR/LIQ/SOLID) , OBSERVE HAZARD PRECAUTIONS.
Exposure Controls
Respiratory Protection:IF TLV OF PRODUCT/COMPONENT EXCEEDED, NIOSH/MSHA
AIR SUPPLIED RSPRTR ADVISED IN ABSENCE OF ENVIRONMNTL CONTROL. OSHA
REGS PERMIT NIOSH/MSHA RSPRTR UNDER SPECIFIED CONDITIONS.
ENGINEER/ADMIN CONTROLS S HOULD BE IMPLEMENTED TO REDUCE EXPOS.
Ventilation:PROVID SUFFICIENT MECHANICAL (GENERAL &/OR LOCAL EXHAUST)
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:WEAR RESISTANT GLOVES (NITRILE RUBBER)
Eye Protection:CHEM SPLASH GOGGLES, SAFETY GLASSES
Other Protective Equipment:TO PREVENT REPEATED/PROLONGED SKIN CONTACT,
WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:KEEP AREA CLEAN/FREE (LEAKS/SPILLS). WASH
W/SOAP & WATER BEFORE HANDLING FOOD & DRINK. WASH CONTAM CLOTH
BEFORE REUSE.
Supplemental Safety and Health
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:300 TO 410F
Vapor Density:> AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:JET BLACK THIN LIQUID WITH A MILD PETROLEUM ODOR.
Percent Volatiles by Volume:63
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:KEEP AWAY FROM OPEN FLAMES, SPARKS & HEAR.
DO NOT WELD NEAR OR AROUND PRODUCT.
Disposal
Waste Disposal Methods:DESTROY BY LIQUID INCINERATION. CONTAMINATED
ABSORBENT MAY BE DEPOSITED IN A LANDFILL IN ACCORDANCE WITH LOCAL,
STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.